MIMAKI JV3-160S Průvodce nastavením stáhnout pdf (Strana 43)

– 3.5 –

1) Make sure that there is no

gap between platen F

(aluminum) and the edge

of the P cover F rubber. If

there is a gap, stick the

rubber appressed against

the platen. The gap may

be detected in mistake.

2) Make sure that platen

cover F is fixed securely

using the platen cover F

mounting screws (attached

on auxiliary side plates R

and L to prevent the cover

from protruding).

3) Check if the media right

edge is set at a position

15mm or more from the

rightmost edge of the

rightmost feed roller:R1

toward the station side or

not.

4) Cleaning or replace a

paper width sensor.

5) Replace a HDC FPC

cable.

6) Replace a slider PCB.

7) Replace a main PCB.

1) Replace a Y axis motor.

2) Replace a Y origin sensor.

3) Replace a IO PCB.

4) Replace a main PCB.

• Media detection has not been

successfully carried out.

• Y-axis origin detection has

not been successfully carried

out.

ERROR50 MEDIA SENSE

ERROR51 Y ORIGIN

Error message Cause Corrective measure

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 169 170

Žádné komentáře

MIMAKI JV3-160S Průvodce nastavením Strana 43